OPERATION
L025317 Issue 5 July 2014 3-27
General Property Values
Object Name - Defines the name of the text object, which clearly identifies it
for selection in the Object Selection window.
Object Name - Defines the name of the object.
X-position - Defines the left point of the object in mm.
Y-position - Defines the top point of the object in mm.
Width - Specifies the width of the object in mm (for text objects, this
represents the size of each character).
Height - Specifies the height of the object in mm (for text objects, this
represents the size of each character).
Hatching Mode -
Parameter Set - Defines the marking parameters for the object. Each
object must have a parameter set assigned to it.
Rotation [º] - Rotates the object in clockwise or anti-clockwise direction,
negative values give anti-clockwise rotation.
y Angle [º] - Tilts the object into perspective. Positive and negative values
in degrees are possible.
Horizontal - Alignment - Left, centre, right, none.
Vertical - Alignment - Top, centre, bottom, none.
Mirror x - Mirrors the object horizontally.
Mirror y - Mirrors the object vertically.
Locked - Object may not be edited.
Mark - Prevents/allows marking of the object. Useful for objects that are
only used as a positional aid when creating an object. The Digital Input
option is for special applications only and requires the Conditional and
Mask values.
Reference Position X,Y - Displayed when the reference position is
different to the X,Y position of an object.
To Next Page
Loading...
Need help?
General
