WARNINGS: (1) As supplied, This coder is a class 4 laser
product. During operation, it will emit up to 120
watts of pulsed invisible laser radiation at a
wavelength between 9 and 11 microns. Avoid
eye or skin exposure to direct or scattered
radiation.
(2) This coder must be fitted with class 1 laser
guarding to safeguard against accidental
exposure to direct or scattered radiation before
it is operated or made ready for use.
(3) Guidance on creating and fitting laser guarding
can be found in part 1 of the product manual.
(4) Use of controls or adjustments of performance
or procedures other than those specified in this
manual may result in hazardous radiation
exposure.
(5) The laser print head (D120 ip, D320 ip) is cooled
by compressed air. Air overpressure inside the
laser print head is harmful and may lead to
rupture of the cabinet.
(6) The maximum pressure for the compressed air
supplied into the print head is 4 bar. A pressure
supply of 4 bar must not be exceeded at any
time.
(7) The laser print head has two air outlets. Both
air outlets must be kept clear as blocked air
outlets can cause an overpressure inside the
cabinet and may lead to rupture (potential
hazard). Please do not swap air inlet and outlet
(8) The length of the compressed air outlet hose
must not exceed 4 metres.
To Next Page
Loading...
Need help?
General
