Domino Gx-Series User Manual

Speed = Distance Between Photocells ¸ Time Between Photocell Triggers
1.Notes
To use a photocell encoder, ensure the "Print speed mode" of labels that are
sent to the print group is set to "External". see Label Settings on page 134.
2.
The print speed of the first label is set by the label's "Production speed (m/
min)" setting. see Label Settings on page 134.
To setup two photocell encoders:
1. If the print group is active, stop the print group. Select STOP, select the print group and
select Stop.
2. Make sure the photocell furthest away from the print head is correctly connected to one of
the controller's I/O inputs:
Controller Type Connection Type
Connection Example
Page Reference
Gx-IC7 NPN see NPN Input on page 39.
Gx-IC7 PNP see PNP Input on page 40.
Gx-IC10 or Gx-OEM NPN see NPN Input on page 48.
Gx-IC10 or Gx-OEM PNP see PNP Input on page 49.
3.
Assign the input function of the photocell furthest from the print head to "Preceded
Product Detect", see Inputs on page 82.
4.
Make sure the photocell closest to the print head is correctly connected to one of the
controller's product detect inputs:
Controller Type Connection Type
Connection Example
Page Reference
Gx-IC7 NPN see
Product Detect Sensor NPN
Connection on page 39.
Gx-IC7 PNP see
Product Detect Sensor PNP
Connection on page 39.
Gx-IC10 or Gx-OEM NPN see
Product Detect Sensor NPN
Connection on page 47.
INSTALLATION
EPT053091 - Issue 5 - 07 May 2021 78

Domino Gx-Series Specifications

General

Brand	Domino
Model	Gx-Series
Category	Controller
Language	English