i-on40 & i-onEX Range 3. Setting and Unsetting
Page 29
A Hold Up Alarm device is
still active. (If a user has
forgotten to reset the device
an installer is not required.)
A part of the system has
been tampered with.
An expander or keypad has
a fault, or the cabling
between parts of the system
has a fault.
The AC supply has stopped
for more than 10 seconds.
The back-up battery has a
problem.
or
Part of the communication
system has a problem.
The system has
detected a fault not covered
by the above categories.
Unsetting the System Using a Keypad
When unsetting the system do not stray from the entry route designated by
the installer. If you do so then you will cause an alarm.
To Next Page
Loading...
Need help?
General
