Eaton i-on User Manual

i-on40 & i-onEX Range 4. Administration
Page 84
Programming Outputs
During programming the installer may allocate some outputs so that they
can be reprogrammed by an Administrator. This section describes how the
Administrator can use those outputs.
For each output you can, if you wish, set an “on” time and an “off” time so
that the output will go on and off at fixed times each day. In addition,
Master, Admin and Normal users can switch the output on or off at any
time.
To program an output:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The bottom line of the display
shows:


6. Press  until the display shows:
Note: This option is only visible if the
installer has allocated some
outputs to you.


7. Press .
The top line of the display shows
the physical address of the first in a
list of outputs that are available to
edit. The bottom line shows either
the name of the output (if the
installer has given the output a
name) or the output number.



Eaton i-on Specifications

General

Brand	Eaton
Model	i-on
Category	Security System
Language	English