Eaton i-on User Manual

4. Administration i-on40 & i-onEX Range
Page 70
If the control unit does not
recognise a prox tag, the display
shows:


9. Press  to end the test.


ARC Reporting
If your alarm system is connected to an Alarm Receiving Centre by
telephone line then there may be a time when they or the installer ask you
to test the line. To do this:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The display shows:


6. Press  until you see:


7. Press .
The bottom line of the display
shows the first in a list of the
available telephone numbers
(there are only two).


8. Press  or  to select the number
you wish to call.


9. Press .
The keypad display shows the
progress of the call. Check with the
receiving centre that the test call
arrived. If the call fails the display
will show “Call failed” followed by a
reason.



Eaton i-on Specifications

General

Brand	Eaton
Model	i-on
Category	Security System
Language	English