Eaton i-on User Manual

i-on40 & i-onEX Range 4. Administration
Page 89
30. Press  when you have finished
making changes.
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:


31. Press  to leave the menu.
Note: You can switch the output on and off from the Menu by selecting
Outputs On/Off (see page 105).
If you want to program a remote control to control the output, see
page 93.
Programming Remote Controls and Two-way
Fobs
Master users can re-program buttons on an i-fb01, or the “*” button on a
FOB-2W-4B, after the devices have been assigned to a user.
If a Master or Admin user changes the partitions assigned to another user,
then the user themselves must change the partitions assigned to their own
i-fb01 (see “Programming Set/Unset below) or FOB-2W-4B (see “Re-
assigning FOB-2W-4B Partitions” on page 93).
Programming Set/Unset
To program an i-fb01 remote or the FOB-2W-4B “*” button to set or unset:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .


6. Press  until the display shows:



Eaton i-on Specifications

General

Brand	Eaton
Model	i-on
Category	Security System
Language	English