3. Setting and Unsetting i-on40 & i-onEX Range
Page 32
Figure
Radio Keypad
Note: The radio keypad does not show the status of the alarm system at all.
The left hand “Transmit” LED glows only to show that the keypad is
sending a command to the control unit.
Using a Remote Control
Setting
Note: You must ask your Administrator to provide a suitably programmed
remote control, see page 89.
Secure all your windows and doors.
Make sure the system is in standby, and that you can hear the warning
tones from the internal sounders.
1. Press the appropriate button on the remote control, either full set (A)
or part set (B) (see Figure 8).
Figure
Remote Control Button Functions.
The keypad sounds the exit warning tone.
To Next Page
Loading...
Need help?
General
