3-19
3.3-9 Load Performance Defaults
This option opens a dialog box that lets you install performance defaults for
all appropriate items in the Setup Utility: Press <Y> and the <Enter> to
install the defaults. Press <N> and then <Enter> to not install the defaults.
If you want to make your system for greater effectiveness, then install the
performance defaults. If you only want to install performance defaults for
a specific option, select and display that option, and then press <F6>.
3.3-10 Load Optimized Defaults
This option opens a dialog box that lets you install optimized defaults for all
appropriate items in the Setup Utility. Press <Y> and then <Enter> to
install the defaults. Press <N> and then <Enter> to not install the de-
faults. The optimized defaults place demands on the system that may be
greater than the performance level of the components, such as the CPU
and the memory. You can cause fatal errors or instability if you install the
optimized defaults when your hardware does not support them. If you only
3.3-11 Set Supervisor/User Password
When this function is selected, the following message appears at the center
of the screen to assist you in creating a password.
ENTER PASSWORD
Type the password, up to eight characters, and press <Enter>. The password
typed now will clear any previously entered password from CMOS memory.
You will be asked to confirm the password. Type the password again and
press <Enter>. You may also press <Esc> to abort the selection.
To disable password, just press <Enter> when you are prompted to enter
password. A message will confirm the password being disabled. Once the
password is disabled, the system will boot and you can enter BIOS Setup
freely.
PASSWORD DISABLED
If you have selected “System” in “Security Option” of “BIOS Features
Setup” menu, you will be prompted for the password every time the system
reboots or any time you try to enter BIOS Setup.
If you have selected “Setup” at “Security Option” from “BIOS Features
Setup” menu, you will be prompted for the password only when you enter
BIOS Setup.
want to install setup defaults for a specific option, select and display that
option, and then press <F7>.
Notes: To load performance defaults may make system unstable or unbootable.
To Next Page
Loading...
Need help?
General
