SOI/DT 2002-06 eb 13 599 35 27-25
2.7 “SKIP/RESET” button
Thus button performs two functions:
♦ Cancels the programme: Press the button until the cycle LEDs switch off. The display will show three
flashing hyphens.
♦ Selects special programmes: In the programme selection and execution phases, this button can be
used to cancel certain phases of the programme so that the appliance effectively performs a special
cycle. In the programme execution phase, the appliance must be paused.
The cycle normally performed by the appliance consists of the following phases:
Wash » Rinses » Spin (drying for washer-dryers)
Ö When the button is pressed once:
Rinses » Spin (drying for washer-dryers)
Ö When the button is pressed twice:
Spin (drying for washer-dryers)
Ö When the button is pressed three times:
Drain
ÖWhen the button is pressed four times:
Cancel programme
If the PRE-WASH option is selected, it can be cancelled by pressing this button, so that the appliance
performs the wash only.
2.8 “DELAYED START” button
This button can be used to delay the start of the programme for up to 24
hours. The selected delay time is shown on the display for approximately 5
seconds, after which the duration of the programme is displayed.
The DELAYED START option must be selected after selecting the
programme and before pressing START/PAUSE.
The delay countdown is decremented at intervals of one hour, and is shown
on the display.
To modify or cancel the delayed-start time:
- press START/PAUSE to set the appliance to PAUSE.
- press the DELAYED START button until the display shows the new delay time or 0h.
- press START/PAUSE again.
The porthole door remains locked during the entire delayed-start period (the door pilot lamp lights).
If it is necessary to open the porthole door, set the appliance to PAUSE mode. After re-closing the door,
press START/PAUSE.
If the SOAK option has been selected, the delay time becomes the soak time.
To Next Page
Loading...
Need help?
General
