SOI/DT 2002-06 eb 54 599 35 27-25
7.10 Exiting the diagnostics cycle
To exit the diagnostics cycle, switch the appliance off, then on,
then off again.
7.11 Operating time counter
A specific procedure can be used to display the total number of hours of operation of the appliance, which
are counted as from the first time it is operated. This option is available on models with display only
. The
maximum value that can be stored in memory is 6,550 hours of operation.
Ö only the time of the normal programmes is counted (cycle diagnostics are not included).
Ö the effective time of the cycles is counted (i.e. not including pauses, delayed start times, rinse hold
periods and the soak phases).
Ö the accuracy of the counter is to within 30 seconds for each programme.
Ö only whole hours of operation are displayed (1 hr 59 minutes is displayed as 1 hour)
7.11.1 Reading the operating time
Ö reset the running programme and switch the
appliance off
Ö press buttons FABRICS (1) and button
TEMPERATURE (2) simultaneously and then,
holding then down, switch the appliance on with
button ON/OFF
Ö hold down buttons for at least 4 seconds
Displaying the operating time
The operating time is displayed two digits at a time. The first pair of digits shows the thousands and
hundreds; the second pair shows tens and units.
For example, a total operating time of 6,550 hours will be displayed as follows:
1 → 2 → 3 →
Blank display for two seconds
The first pair of digits is
displayed for two seconds
:
- thousands (6)
- hundreds (5)
The second pair of two digits is
displayed for two seconds:
- tens (5)
- units (0)
To Next Page
Loading...
Need help?
General
