SOI/DT 2002-06 eb 50 599 35 27-25
7.8 Canceling the last alarm condition
To cancel the last memorised alarm condition press button no. 2 (TEMPERATURES) and no. 4 at the same
time during one of the 8 phases of the diagnostics cycle and not in the alarm or configuration reading
positions.
To check for correct operation, go back to the alarm reading position (the L10 LED is on); the display should
show E00.
The alarm is cancelled also when a new configuration is given to the main PCB.
To Next Page
Loading...
Need help?
General
