Non-resettable grand total locked menus and parameters Table 6-2:
Display Parameter/Menu Action/Setting locked
InPut Input All Input type selection menu parameters
GtotU Grand total units Set grand total units
GrtCf Grand total conversion
factor
Enter the Grand total conversion factor menu
Grtot DECI-
MAL
Grand total decimal point Enter the grand total display decimal point
FActr K-Factor All K-Factor menu parameters
SCALE Scale All Scale menu parameters
CAL Calibrate All Calibrate menu parameters
GrtSt Grand total reset All Grand total reset menu parameters
PASS GT Password grand total Enter the grand total reset passwords
Grtot
ALARM
Grand total alarm All grand total alarm output menu parameters
FILTER Filter Enter Filter parameter
CUTOFF Low-flow cutoff Enter Low-flow cutoff parameter
The above menus remain accessible; however the parameters listed above within the
menus are locked and may not be changed.
6.11
Custom (CUSTOM)
The
Custom menu is used to modify the initial programming menus that appear in the
Main Menu when the Menu button is pressed in Run Mode.
CAUTION!
PROGRAMMING AND OPERATION HAZARD
Changing the default menu setup with the Custom menu feature may change the setup and
operation procedures described in this manual. Only operators familiar with the programming
and operation of this unit should use this feature.
Eight menu positions are available. Menu positions 6 and 7 are factory programmed for
Setup and Advanced.
Product advanced features
76 LTM Internal Display
To Next Page
Loading...
Need help?
General
