Useful Functions
36
Using 3D Glasses
Use the 3D Glasses (ELPGS03) to view 3D images.
s
p.73
c
The 3D Glasses come with protective stickers. Remove the protective stickers before use.
Charging the 3D Glasses
Use the USB cable to connect the 3D Glasses to the USB Charging Adapter, and then connect the USB Charging
Adapter to an electrical outlet.
c
You can also charge by connecting the 3D Glasses to the USB (TypeA) port on the rear of the projector
with the USB cable (only when the projector is turned on).
Attention
•
Only connect to an electrical outlet that uses the voltage displayed on the adapter.
•
Note the following points when handling the USB cable.
- You should not bend, twist, or pull the cable with too much force.
- You should not modify the cable.
- You should not perform wiring near an electric heater.
- You should not use the cable if it is damaged.
Pairing 3D Glasses
To create 3D images, the 3D Glasses need to be paired with the projector.
Press the [Pairing] button for a while on the 3D Glasses to start pairing. See the User's Guide for the 3D Glasses
for more information.
c
•
For 3D Glasses that have not been used, pairing is performed when the 3D Glasses are turned on. You
do not need to perform pairing if 3D images can already be viewed correctly.
•
Once pairing has been performed, you can view 3D images the next time the devices are turned on.
•
You can perform pairing within a range of three meters from the projector. While pairing is being
performed, make sure you stay within a range of three meters from the projector. Otherwise, pairing
may not be performed correctly.
•
If synchronization cannot be performed within 30 seconds, pairing is automatically canceled. When
pairing is cancelled, 3D images cannot be viewed because pairing fails.
To Next Page
Loading...
Need help?
Projection Specifications
Power
Weight and Dimensions
