Troubleshooting
58
Indicators Status Remedy
(blue)
(orange)
High Temp Error
(Overheating)
The internal temperature is too high.
•
The lamp turns off automatically and projection stops. Wait for
about five minutes. When the fan has stopped, disconnect the
power cord.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s p.68
•
If turning the power back on does not clear the problem, stop
using the projector and remove the power plug from the elec‐
trical outlet. Contact your local dealer or the nearest Epson repair
center.
s Epson Projector Contact List
Indicator status during normal operation
: Flashing : Lit : Off
Indicators Status Remedy
(blue)
Standby condition
When you press the button on the remote control or the
control panel, projection starts after a short wait.
(blue)
Warm-up in progress
Warm-up time is about 30 seconds.
The power-off operation is disabled while the projector is warm‐
ing-up.
Cool-down in pro‐
gress
All operations are disabled while the projector is cooling-down.
The projector enters standby condition when cool-down is com‐
plete. If for any reason the power cord is disconnected during
cool-down, wait until the lamp has cooled down sufficiently
(about 10 minutes), reconnect the power cord, and then press
the
button on the remote control or the control panel.
(blue)
Projection in pro‐
gress
The projector is operating normally.
c
•
Under normal operating conditions, the o and m indicators are off.
•
When the Illumination function is set to Off, all indicators are off under normal projection conditions.
s Extended - Operation - Illumination p.51
When the Indicators Provide No Help
Check the problem
Check the following table to see if your problem is mentioned, and go to the appropriate page for information
on handling the problem.
To Next Page
Loading...
Need help?
Projection Specifications
Power
Weight and Dimensions
