Troubleshooting
63
Check Remedy
(Only when projecting images from a video
device)
Are the color saturation and tint adjusted cor‐
rectly?
Adjust the Color Saturation and Tint settings from the Config‐
uration menu.
s Image - Color Saturation/Tint p.46
Images appear dark
Check Remedy
Is the image brightness set correctly?
Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.46
Is the contrast adjusted correctly?
Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.46
Is it time to replace the lamp? When the lamp is nearly ready for replacement, the images be‐
come darker and the color quality becomes poorer. When this
happens, replace the lamp with a new lamp.
s p.70
Projection stops automatically
Check Remedy
Is Sleep Mode enabled?
If no image signal is being input and no operations are made for
the time that is set in advance, the lamp turns off automatically,
and the projector enters standby status. The projector returns
from standby status when you press the
button on the re‐
mote control or the control panel. If you do not want to use Sleep
Mode, change the setting to Off.
s Extended - Operation -
Sleep Mode p.51
Problems when projection starts
The projector does not turn on
Check Remedy
Is the power turned on?
Press the
button on the remote control or the control panel.
Is Child Lock set to On? When Child Lock is set to On from the Configuration menu, hold
down the
button on the control panel for approximately
three seconds, or perform operations from the remote control.
s Settings - Lock Setting - Child Lock p.49
Do the indicators turn on and off when the
power cord is touched?
Turn off the projector, and then disconnect and reconnect the
projector's power cord. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
center.
s Epson Projector Contact List