Epson EH-TW5200 User Manual

Maintenance
70
Replacing Consumables
Replacing the air filter
c
Dispose of used air filters properly in accordance with your local regulations.
Filter frame: ABS
Filter: Polyurethane foam
a
Press the button on the remote
control or the control panel to turn off
the power, and then disconnect the
power cord.
b
Open the air filter cover.
c
Remove the old air filter.
Grip the air filter cover tab and pull it
straight up.
d
Install the new air filter.
Slide in the air filter until it clicks into place.
e
Close the air filter cover.
Replacing the lamp
Warning
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be
broken. If replacing the lamp of a projector that has been suspended from the ceiling, you should always
assume that the lamp is cracked, and remove the lamp cover with care. When you open the lamp cover,
small shards of glass could fall out. If any shards of glass get into your eyes or mouth, contact a doctor
immediately.

Epson EH-TW5200 Specifications

Projection Specifications

native resolution	1080p (1920 x 1080)
f-number	1.58 - 1.72
focal length	16.9 - 20.28 mm
zoom ratio	1 - 1.2
throw ratio	1.22 - 1.47 (Wide - Tele)
lamp type	200W UHE
lamp life (normal / eco)	5, 000 hours / 6, 000 hours
screen size (projected distance) - zoom : wide	34” - 328” [0.9 - 9.0 m]
screen size (projected distance) - zoom : tele	34” - 328” [1.08 - 10.8 m]

Brightness and Contrast

colour light output (normal)	2, 000 lm
white light output (normal)	2, 000 lm
contrast ratio (auto iris: on)	15, 000:1

Audio and Speaker

sound output	2W Monaural

Power

power supply voltage	100 - 240 V AC ±10%, 50/60 Hz
power consumption (lamp on - normal / eco)	287W / 217W
standby power consumption	0.31W

Operating Conditions

operating temperature	5 - 35 °C
operating altitude	0 - 3, 000 m
fan noise (normal / eco)	37dB / 29dB

Weight and Dimensions

weight	2.8 kg
dimension excluding feet	247 x 297 x 105 mm