Epson EH-TW5200 User Manual

Troubleshooting
56
Problem Solving
Reading the Indicators
You can check the status of the projector from the flashing and lit , (operation indicators), o and m
on the control panel.
Refer to the following table to check the projector's status and how to remedy problems shown by the
indicators.
Indicator status during an error/warning
: Lit : Flashing : Status maintained : Off
Indicators Status Remedy
(blue)
(orange)
Replace Lamp
It is time to replace your lamp. Replace the lamp with a new lamp
as soon as possible.
s p.70
The lamp may explode if you continue to use it in this status.
(blue)
(orange)
High Temp Warning
You can continue projecting. If the temperature rises too high
again, projection stops automatically.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s p.68

Epson EH-TW5200 Specifications

Projection Specifications

native resolution	1080p (1920 x 1080)
f-number	1.58 - 1.72
focal length	16.9 - 20.28 mm
zoom ratio	1 - 1.2
throw ratio	1.22 - 1.47 (Wide - Tele)
lamp type	200W UHE
lamp life (normal / eco)	5, 000 hours / 6, 000 hours
screen size (projected distance) - zoom : wide	34” - 328” [0.9 - 9.0 m]
screen size (projected distance) - zoom : tele	34” - 328” [1.08 - 10.8 m]

Brightness and Contrast

colour light output (normal)	2, 000 lm
white light output (normal)	2, 000 lm
contrast ratio (auto iris: on)	15, 000:1

Audio and Speaker

sound output	2W Monaural

Power

power supply voltage	100 - 240 V AC ±10%, 50/60 Hz
power consumption (lamp on - normal / eco)	287W / 217W
standby power consumption	0.31W

Operating Conditions

operating temperature	5 - 35 °C
operating altitude	0 - 3, 000 m
fan noise (normal / eco)	37dB / 29dB

Weight and Dimensions

weight	2.8 kg
dimension excluding feet	247 x 297 x 105 mm