Epson EH-TW5200 User Manual

Maintenance
71
Caution
•
Do not touch the lamp cover immediately after turning off the projector as it is still hot. Wait until the lamp
has cooled down sufficiently before removing the lamp cover. Otherwise, you could get burnt.
•
We recommend the use of genuine EPSON option lamps. The use of non-genuine lamps may affect projection
quality and safety.
Any damage or malfunction caused by the use of non-genuine lamps may not be covered by Epson's warranty.
a
Press the button on the remote
control or the control panel to turn off
the power, and then disconnect the
power cord.
b
Loosen the lamp cover fixing screw.
c
Remove the lamp cover.
Slide the lamp cover straight forward and
remove it.
d
Loosen the two lamp fixing screws.
e
Remove the old lamp.
Grip the projection and pull it straight out.
f
Install the new lamp.
Make sure the lamp is facing the correct
direction and press it in.
g
Tighten the two lamp fixing screws.

Epson EH-TW5200 Specifications

Projection Specifications

native resolution	1080p (1920 x 1080)
f-number	1.58 - 1.72
focal length	16.9 - 20.28 mm
zoom ratio	1 - 1.2
throw ratio	1.22 - 1.47 (Wide - Tele)
lamp type	200W UHE
lamp life (normal / eco)	5, 000 hours / 6, 000 hours
screen size (projected distance) - zoom : wide	34” - 328” [0.9 - 9.0 m]
screen size (projected distance) - zoom : tele	34” - 328” [1.08 - 10.8 m]

Brightness and Contrast

colour light output (normal)	2, 000 lm
white light output (normal)	2, 000 lm
contrast ratio (auto iris: on)	15, 000:1

Audio and Speaker

sound output	2W Monaural

Power

power supply voltage	100 - 240 V AC ±10%, 50/60 Hz
power consumption (lamp on - normal / eco)	287W / 217W
standby power consumption	0.31W

Operating Conditions

operating temperature	5 - 35 °C
operating altitude	0 - 3, 000 m
fan noise (normal / eco)	37dB / 29dB

Weight and Dimensions

weight	2.8 kg
dimension excluding feet	247 x 297 x 105 mm