Light Status Solutions
Flashing alternately
A maintenance box is at the end of its
service life.
The maintenance box needs to be replaced.
Flashing alternately
The maintenance box cannot be recognized.
You cannot install a maintenance box that has already
been used in another printer. Install a new
maintenance box.
Flashing alternately
The maintenance box is not installed.
Install the maintenance box again.
Flashing alternately
There is not enough free space left in the
maintenance box to perform cleaning.
Replace the maintenance box before cleaning. You
may still be able to print even if you cannot perform
cleaning.
The printer has started in recovery mode
because the rmware update failed.
Follow the steps below to try to update the rmware
again.
1. Connect the computer and the printer with a USB
cable. (During recovery mode, you cannot update the
rmware over a network connection.)
2. Visit your local Epson website for further
instructions.
A printer error has occurred. Open the printer cover and remove any paper inside
the printer. Turn the power
o
and on again.
If the error continues to occur after turning the power
o and on again, contact Epson support.
Related Information
& “Removing Jammed Paper” on page 99
& “Contacting Epson Support” on page 131
& “Installing the Latest Applications” on page 91
Checking the Printer Status - Windows
1. Access the printer driver window.
2. Click EPSON Status Monitor 3 on the Maintenance tab.
Note:
❏ You can also check the printer status by double-clicking the printer icon on the taskbar. If the printer icon is not
added to the taskbar, click Monitoring Preferences on the Maintenance tab, and then select Register the shortcut
icon to the taskbar.
❏ If EPSON Status Monitor 3 is disabled, click Extended Settings on the Maintenance tab, and then select Enable
EPSON Status Monitor 3.
Related Information
& “Accessing the Printer Driver” on page 43
User's Guide
Solving Problems
98
To Next Page
Loading...
Need help?
General