18 Displaying and Adjusting the Image
Projecting the Image
Make sure your projector and other equipment are set up as described
on page 45. Then follow the instructions below to start the projector
and display an image.
Turning On the Projector
Turn on any connected computer or video equipment before starting
the projector so it can automatically detect and display the image
source. If you turn on the projector first, or have multiple pieces of
connected equipment, you may have to select the image source
manually (see page 20).
Follow these steps to turn on the projector:
1. Remove the lens cap.
2. Plug one end of the power cable into the projector, and the other
end into a grounded electrical outlet.
3. Wait until the
Power light remains orange.
note
To shut down the projector,
see page 29. Shutting down
the projector correctly
prevents premature lamp
failure and possible damage
from overheating.
note
If the Direct Power ON
feature has been enabled (as
described on page 30), the
Power light flashes green
(instead of orange) when
you plug it in. When the
light stays green, the
projector is ready for use.
Power light
To Next Page
Loading...
Need help?
General