Displaying and Adjusting the Image 29
Shutting Down the Projector
When you’ve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. Turn off any equipment plugged into the projector.
2. To turn off the projector, press the red P
Power button on the
projector or remote control.
You see a confirmation message. (If you don’t want to turn it off,
press any other button.)
3. Press the P
Power button again. The projector lamp is turned
off. The
Power light may flash orange for about 30 seconds as the
projector cools down and then stays orange. The exhaust fan shuts
off.
If you want to turn the projector on again, make sure the
Power
light is not flashing orange. Then press the P
Power button.
4. If you extended the adjustable front foot, press up on the blue
foot release lever to retract it.
5. Replace the lens cap and unplug the power cord.
6. If you’re using a remote control, set its
ON/OFF switch to OFF.
note
Turn off this product when
not in use to prolong the life
of the projector.
Power button
To Next Page
Loading...
Need help?
General