Using the Remote Control 41
Adjusting Color Corrections for a New Surface
Adjust the correction values if you’re projecting on a new surface or in
a new location.
1. Press the
Wall Shot button on the remote control or projector
while you’re projecting an image. Make sure Wall Shot is on.
2. Press the
Wall Shot button a couple of times until you see Wall
Shot Readjustment
as the status in the upper right corner of
your screen.
You see a sequence of colors flash for about five seconds as the
projector adjusts the color correction values for the new
projection surface.
Operating Your Computer with the
Remote Control
If you’ve connected a computer to the projector with a USB cable, as
described on page 49, you can use the remote control in place of your
computer’s mouse. This gives you more flexibility when delivering
slideshow-style presentations, since you won’t have to stand next to
the computer to change slides.
■ Use the Page buttons to move through a slideshow.
Page up or down
to change slides
in PowerPoint
To Next Page
Loading...
Need help?
General