56 Connecting to Computers, Cameras, and Other Equipment
Connecting to a Digital Camera or
Other Device
You can connect your digital camera, USB flash memory drive, USB
hard drive, or digital photo storage device, such as the Epson P-1000,
to the projector using the USB cable specified for your device. Then
you can use your camera’s slideshow function or the projector’s
EasyMP CardPlayer feature (see page 99) to present images.
1. Make sure there is no card inserted in the projector’s card slot.
2. Connect the flat end of the USB cable to the
USB Type A port
on the projector, as shown.
3. Connect the square end of the cable to your camera or other
device.
Removing the USB Cable
If you’re using CardPlayer to project your images, close the program
before you remove the USB cable from the projector.
1. Position the cursor over the
EJECT button in the upper right
corner of the CardPlayer screen.
2. Press the
Enter button on the remote control to close CardPlayer.
3. Disconnect the USB cable.
note
Use a cable less than 10 feet
long and connect the camera
directly to the projector.
Your projector may not
function correctly if you use
a longer cable or connect
your camera to a USB hub.
To Next Page
Loading...
Need help?
General