F Slider
U “Slider” on page 14
G Side cover
Open the side cover to remove the slider for chip unit replacement. Always close the side cover securely after
inserting the slider.
H Waste Ink Bottle holder
Place the Waste Ink Bottle in this holder.
I Waste Ink Bottle
Waste ink collects in this bottle.
Replace with a new Waste Ink Bottle when the level approaches the line.
J Stopper
The stopper prevents splatter when the waste ink is ejected.
Fit the stopper closely to the mouth of the Waste Ink Bottle in most situations.
K Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the Waste Ink Bottle while the printer is in
use.
L AC inlet
Connect the supplied power cable here.
M LAN port
Connects the LAN cable.
N Data light
The network connection status and data reception are indicated by a lit or flashing light.
On : Connected.
Flashing : Receiving data.
O Status light
The color indicates the network transmission speed.
Red : 100Base-TX
Green : 1000Base-T
P USB port
Connect the USB cable here.
Q Control panel
U “Control panel” on page 15
SC-F6200 Series/SC-F6000 Series User's Guide
Introduction
9
To Next Page
Loading...
