J
Leave a 10 to 20 cm wide section in the center
of the media, and cut at least 25 cm in height
from the left and right corners of the media.
Cutting the media prevents feeding problems,
such as the left and right corners of media
being folded and caught at the start of take-up.
For the subsequent steps, see the following depending
on how the media is rolled.
For information on taking-up with printed side in, see
U “Take-up with the Printed Side Facing In” on
page 37.
For information on taking-up with printed side out,
see U “Take-up with the Printed Side Facing Out”
on page 39.
Take-up with the Printed Side
Facing In
A
While pulling the center of the media straight
down, wrap it around the roll core from back to
front, and affix it using commercially available
adhesive tape.
c
Important:
Attach the media to the take-up roll core
with the media pulled tightly. If media is
attached loosely, the media may move
around during take-up.
SC-F9300 Series User's Guide
Basic Operations
37
To Next Page
Loading...
Need help?
General