Printable area
The left and right edges of media recognized by the printer varies as shown below according to the Media
Size Check settings.
Media Size Check On : The printer automatically detects the left and right edges of the loaded media.
When media edge plates are attached, within 5 mm of the left and right edges of the
media is recognized as the media edge.
The edges of the media are not detected correctly if the media edge plates are not
attached correctly.
U “Loading media” on page 27
Media Size Check Off : The center of the black rectangle on the heater's label (shown in the illustration below) is
the standard position for the right edge of the media. Regardless of the width of the
loaded media, the left edge of the media is determined to be 1,626 mm (64 inches) from
the standard position for the right edge.
SC-F9300 Series User's Guide
Basic Operations
52
To Next Page
Loading...
Need help?
General