Ink other than High Density Black Ink
High Density Black Ink
c
Important:
Press the ink inlet cap down firmly so that it
does not detach. If the slider comes into
contact with the ink inlet cap when pulling it
out, the cap could be damaged.
M
Close the slider ink inlet cover.
When ink adheres to the heat shield when
refilling the ink, remove the heat shield and
clean it.
U “Cleaning the Heat Shield” on page 83
Procedure for stirring the
High Density Black Ink
A characteristic of High Density Black Ink is that
sedimentation occurs easily. Stir the ink in the ink
tank once a week. There may be color differences in
the printouts if printing is performed when
sedimentation has occurred.
You can stir the ink whenever you want, regardless if
you are printing or if the printer is on or off.
Before starting this procedure, be sure to read the
following:
U “Precautions regarding maintenance” on page 59
SC-F9300 Series User's Guide
Maintenance
71
To Next Page
Loading...
Need help?
General