FlexRadio Systems Flex-3000 User Manual

S E T U P F O R M C H A P T E R 4
Cat Control
Figure 121: CAT Control
 Enable CAT: Check this box to open the com port using the settings below. Note that you will
need to uncheck this box in order to adjust the settings.
 Port: Com port number to use. If using N8VB’s vCOM utility, note that you will use one end of
the null-modem pair here and the other on the third-party software (e.g.. HRD).
 Baud: The speed at which to transfer data.
 Parity: Sets whether to send a parity bit.
 Data: Sets how many data bits are sent with each byte.
 Stop: Sets whether to send a stop bit.
[The rest of this page has been left blank intentionally]
106  2003-2009 FlexRadio Systems

FlexRadio Systems Flex-3000 Specifications

General

Brand	FlexRadio Systems
Model	Flex-3000
Category	Transceiver
Language	English