FlexRadio Systems Flex-3000 User Manual

2 PowerSDR Installation & Setup
Upgrading From an Earlier Version
We recommend that you leave older versions of PowerSDR installed when upgrading from a previous
version. After reviewing the new version and verifying that your setup works, uninstalling previous
versions is fine (but not necessary). Note that in order to completely remove previous versions you
must manually delete the database file (PowerSDR.mdb) from the application directory (usually
c:\Program Files\FlexRadio Systems\PowerSDR vn.n.n).
PowerSDR Installation
Download PowerSDR v1.18.0 or later from the FlexRadio downloads page at
http://support.flex - radio.com/Downloads.aspx?fr=1 to a directory on your hard drive (we recommend
saving to the Desktop). If you downloaded the zip file, extract its contents. Double click the Setup file
(Setup.exe) to start the installation process. The PowerSDR installation will prompt you to install the
.NET framework version 1.1
1
if it is not installed and it will point you to the appropriate web address for
downloading as seen in Figure 15.
Figure 15: Prompt for .NET Framework
Follow the instructions to install the framework using the download from Microsoft’s website and then
restart the Setup.exe program. You should see the screen shown in Figure 16.
1
Multiple versions of the .NET Framework can reside on your computer side by side.
21  2003-2009 FlexRadio Systems
Chapter
2

FlexRadio Systems Flex-3000 Specifications

General

Brand	FlexRadio Systems
Model	Flex-3000
Category	Transceiver
Language	English