FlexRadio Systems Flex-3000 User Manual

O P E R A T I N G F O R M S C H A P T E R 5
Record Options
Click Options at the top of the Wave Form (see Figure 130) to open the following form:
Figure 131: Wave Recording Options
The Wave Record Options can be used to modify what is recorded in either receive or transmit modes.
Receive
 Pre-Processed Audio will record the whole bandwidth of the receiver input. The bandwidth is
determined by the sample rate you set on the Setup Form-Audio Tab, Primary Sub-Tab. This is
useful for playing back through the console at a later time (e.g. for demonstration purposes).
 Post-Processed Audio will record only the filtered, AGC’d audio as you hear it coming out of
the speaker. This is useful for playing back the received audio through a typical wav file player.
Transmit
 Pre-Processed Audio will capture the audio as it is seen at the microphone input without any
of the effects of filtering, compression, companding, equalization or any other audio processing
features that may be turned on in the transmit chain.
 Post-Processed Audio allows the recording to capture the audio after it has been filtered,
compressed, companded, equalized or modified by any other audio processing feature turned
on in the transmit chain.
Sample Rate
Sets the sample rate at which the wave file will be recorded.
[The rest of this page has been left blank intentionally]
118  2003-2009 FlexRadio Systems

FlexRadio Systems Flex-3000 Specifications

General

Brand	FlexRadio Systems
Model	Flex-3000
Category	Transceiver
Language	English