F R O N T C O N S O L E C H A P T E R 3
Tune Step by clicking either of the – or + buttons, clicking the mouse wheel button (or using Ctrl +
Left/Right Arrow).
The Save button quickly saves a frequency, mode and filter. The saved frequency is shown in the box
to its left. The Restore button restores the most recently saved frequency (displayed), mode and filter.
(3) VFO B
Split Transmit Frequency MultiRX Frequency
Figure 34: VFO B
The operation of VFO B is similar to that of VFO A. However, VFO B is used only in specific instances.
However, VFO B is used only in specific instances. When operating split (SPLT button under VFO), VFO
B displays in red the transmit frequency (and TX indicator is red) When activating the multi receive
function (MultiRX button under MultiRX), VFO B displays in yellow the second receive channel's
frequency. Otherwise, it can be viewed as a storage container to copy VFO data to (see the VFO
Controls section on page 55).
(4 ) Multimeters
Figure 35: Multimeter
The multimeter displays both digitally and graphically various RX and TX signal parameters as
determined by the selection from the (two) drop down boxes at the top.
The text display below the meter selections shows the digital data for either the receiver or the
transmitter (Signal strength in Figure 35 above). The lower display at the bottom of this section shows
the data graphically as an edge meter. Alternatively a bar graph display can be selected (see the
description of the Setup Form - Appearance Tab, Meter Sub-Tab on page 102).
[The rest of this page has been left blank intentionally]
38 2003-2009 FlexRadio Systems
To Next Page
Loading...
Need help?
General
