FlexRadio Systems Flex-3000 User Manual

O P E R A T I O N C H A P T E R 6
1. Follow the Power Up Procedure, described on page 132. Then click the Start/Stop button
(14). Set the following controls as specified in Table 9 below.
Table 9: Initial Control Values for Voice Operation
Ctrl Value
Reference to
Figure 140
VFO A 14.3MHz (1)
RX Meter Signal (4)
TX Meter MIC (4)
BAND 20 (5)
Mode USB (6)
Filter 2.7kHz (7)
Mic Gain 35 (8)
DX Off (8)
CPDR Off (8)
VOX Off (8)
GATE Off (8)
RX EQ Off (8)
TX EQ Off (8)
VAC Off (8)
Display Mode Panadapter (9)
AVG On (9)
PEAK Off (9)
MultiRX Off (10)
SPLT Off (12)
XIT Off (12)
RIT Off (12)
MUT Off (17)
AF 50 (21)
AGC-T 70 (22)
Drive 50 (23)
AGC Med (24)
RX Gain Pre (25)
SQL Off (26)
2. Connect a 50 ohm dummy load to the antenna jack, or tune VFO A (1) to a quiet frequency on
the selected band. Use the TUN (19) button to verify power output on the TX Meter (4) (Set
to Fwd Pwr). If using the integrated ATU click the ATU (20) button to initiate a tuning cycle.
CAUTION: If you are not using the internal ATU then connect a 50 ohm dummy
load, or ensure that the antenna presents a 50 ohm load with a low
SWR. Failing to do so may damage the FLEX-3000 output transistors.
3. Press the Push-to-talk button on the microphone or click the MOX (16) button and speak into
the microphone to transmit your voice. Release the Push-to-talk button or click the MOX (16)
button to switch the transceiver back to receive.
136  2003-2009 FlexRadio Systems

FlexRadio Systems Flex-3000 Specifications

General

Brand	FlexRadio Systems
Model	Flex-3000
Category	Transceiver
Language	English