Inspection Route17
Figure 17.1 shows an example of the inspection list:
• The first inspection route is completed and locked, which is indicated by the check
mark to the right.
• The second inspection route has started. It includes a total of 91 inspection points,
and one of them has been inspected. The second inspection route includes the cur-
rent inspection point in live view, which is indicated by the check mark to the left.
To display the next level in the inspection route structure, tap an item in the list.
Figure 17.2
Figure 17.2 shows an example of a level with inspection points:
• The first inspection point has one or more images and the status is set to “green.”
• The second inspection point is the current inspection point in live view, which is indi-
cated by the check mark to the left.
17.3 Performing an inspection
17.3.1 Preparation
Note This procedure assumes that an inspection route file has been created. For more
information, see section 17.5 Creating an inspection route.
1. Add the inspection route file to the root folder on the memory card.
2. Insert the memory card into the camera.
3. Start the camera.
4. Activate the Inspection Route function by selecting
(Settings) > Save options &
storage > Inspection route > On.
5. The camera is now ready.
17.3.2 Capturing inspection data
Once the camera is prepared, the inspection can start.
Note You can turn off the camera in the middle of an inspection. The camera will al-
ways save all data. When the camera is turned on again, it will display the first uncom-
pleted inspection point.
#T810587; r. AA/74078/74713; en-US
80
To Next Page
Loading...
Need help?
General
