• The functions Program 1 and
Program 2 allow you to programme
up to two heating cycles for each day
of the week. These times will remain
stored and the heater will warm up the
vehicle at these times on these days
every week.
• The function One-Time allows you to
programme one heating cycle for one
specific day.
• The function Active now
automatically switches on the heater.
Programming the functions Program 1
and Program 2
1. Highlight Program 1 and press the right
arrow button.
2. Highlight the day on which the heater
should warm up the vehicle.
3. Press the OK button to confirm the
selection. A cross appears in the box
next to the day to show that this day is
selected.
4. Continue in the same way to select all
the days on which the heater should
warm up the vehicle.
5. To set the time at which the vehicle
should be warmed up, highlight the
time at the top of the display and press
the right arrow button.
6. Press the OK button and the hours
flash. Use the up and down arrow
buttons to adjust the individual settings
and the left and right arrow buttons to
move to the next or previous setting.
7. When you have finished, press the OK
button again to confirm the selection.
You can use the function Program 2 to set
a second cycle, for example different times
on different days or twice on the same day.
The programming procedure is the same
as for the function Program 1.
113
Climate Control
To Next Page
Loading...
Need help?
General
