SECURITY CODE
Each unit incorporates a unique code that
must be entered before the unit will
operate.
If the battery is disconnected or if the unit
has been removed from the vehicle, the
code must be re-entered before the unit
will operate.
LOST SECURITY CODE
If you lose the unique code, contact your
dealer and supply details of your audio unit
along with some proof of identity.
ENTERING A SECURITY CODE
If CODE - - - -, CODE 0000 or ENTER
KEYCODE appears in the display when
you switch on the audio unit, you must
enter the unique code using the station
preset buttons.
6000CD, Sony and Sony DAB
1. Using the station preset buttons enter
the unique code.
2. If you make a mistake entering the
code, re-enter the digits by continuing
to select buttons 0-9. The display will
advance from digit position 1 to 4 and
then back again.
3. Make sure that the complete code is
correct before pressing either the *
preset button or the button between
the navigation buttons to confirm your
selection.
INCORRECT SECURITY CODE
Up to a maximum of 10 unique code entry
attempts are allowed with various
consequences if you get it wrong.
The number of attempts will be shown in
the display.
If the display reverts to CODE another
entry attempt may be made immediately.
If the display shows WAIT 30, the unit will
be locked for 30 minutes. Wait until the
timer counts down to zero. When CODE is
shown in the display, enter the correct
code.
Note: After 10 incorrect attempts the unit
will be permanently inoperative and
LOCKED will be shown in the display. See
your dealer.
253
Audio system security
To Next Page
Loading...
Need help?
General
