Home safe lighting
Switch the ignition off and pull the
direction indicator lever towards the
steering wheel to switch the headlamps
on. You will hear a short tone. The
headlamps will go off automatically after
three minutes with any door open, or 30
seconds after the last door has been
closed.
With all doors closed, but within the 30
second delay, opening any door will result
in the three minute timer starting again.
The home safe lights can be cancelled by
either pulling the direction indicator lever
towards the steering wheel again or by
turning the ignition switch on.
DAYTIME RUNNING LAMPS
The lamps will illuminate when the ignition
is on.
AUTOLAMPS
Note: If you have switched autolamps on,
you can only switch the main beam on when
autolamps has switched the headlamps on.
The headlamps will come on and go off
automatically depending on the ambient
light.
AUTOMATIC MAIN BEAM
CONTROL
WARNINGS
The system does not relieve you of
your responsibility to drive with due
care and attention. A manual
override may be necessary if the system
fails to switch the main beam on or off.
A manual override may be required
when approaching other road users
such as cyclists.
Do not use the system in fog.
CAUTIONS
In cold and severe weather conditions
the system may not function. A
manual override may be necessary in
these cases.
Reflective road signs may be detected
as oncoming traffic and the
headlamps may be switched to
dipped beam.
If the lights of oncoming vehicles are
hidden by obstacles (for example
guard rails) the system may not
deactivate the main beam.
Always fit Ford Original Parts when
replacing headlamp bulbs. Other
bulbs may reduce system
performance.
Check and replace wiper blades
regularly to ensure the camera sensor
has a clear view through the
windscreen. Replacement wiper blades
must be the correct length.
55
Lighting
To Next Page
Loading...
Need help?
General
