Fort VISION User Manual

36
- fertilizer spreader;
- trimming machines for vineyards;
- excavator;
- salt spreaders
- hydraulic group complete with heat exchanger, in
order to apply various types of hydraulically oper-
ated accessories to the machine (ow rate of 20
liters/min. and maximum pressure of 130 bar).
To facilitate the coupling of the equipment, the tractor
has quick connections on both types of lifter.
1.6 GUARDS AND SAFETY DEVICES
DANGER
The machine has been designed to allow its safe use
making inoffensive moving parts through the use of
xed and mobile guardsand security devices. The
manufacturer therefore declines all responsibility
in case of damage caused as a result of tampering
with the protection and safety devices.
1.6.1 NOISE RISK
The sound level (airborne noise) is detected with the
engine running at full speed and vacuum, according
to EN ISO 3744/1997 with the engine at 3600 rpm,
and they were found the following levels:
ENGINE Sound pressure Sound power
level at the level
driving seat LwA (dB) according
LpA (dB) to 2000/14/EC
Brigg Stratton Vanguard 16 84 99
1.6.2 VIBRATION LEVEL
The machine has an ergonomic seat and the body is
supported by 4 special anti-vibration mountings that
give the driver a good ride and maneuvering comfort
of the machine.
The vibration level detected with the engine running at
85% of the rated speed declared by its manufacturer
is of 2.5 m/s
2
.
1.7 TECHNICAL FEATURES
Safety devices:
- Protection of the PTO drive shaft connection (in
the non-standard version 14 Fig. 5).
- Security belt.
- Roll-bar (foldable).
- Driver's seat with operator presence sensor. The
lack of presence of the operator on the seat makes
the machine inoperative (apart when you use
some accessories that allow you to operate only
the PTO without man on board. The appropriate
riser is supplied with the accessory).
- Emergency red mushroom button.
Engine
Brigg Stratton Vanguard two cylinders .......... 16 HP
Engine power .....................................12 Kw (16Cv)
Revolution speed ......................................rpm 3600
Engine starter ................................................electric
Machine
Hydrostatic transmission with two variable capacity
pumps and two hydraulic motors
Track width ..................................................mm150
Lower rolls .....................................n. 3 on each side
Track tensioners: automatic up to mat. 600795 -
manuals from mat. 600829.
Hydraulic system ......................with heat exchanger
PTO connection ................................ diameter 62/65
Slotted 3-point connection ...............................1”3/8
3-point connection with hydraulic lifter at 180 bar
Hydraulic outlets ...................................... l/min 9/18
Lifting load ...................................................Kg 200
Max. speed on the surface ......................Km/h 0-6,6
Max. front slope with operator .......................... 26%
Max. cross slope with operator ........................10%
Hydraulic oil tank capacity ................................. l 17
Electrical system .............................................. V 12
Fuel tank capacity ...............................................l 10
PTO: 1100 rpm at 3600 rpm engine anti-clockwise
rotation direction.
Weight (mass) .............................................Kg 450
Dimensions:
See gure 6 / A: machine with automatic idler (rst
version).
See gure 6 / B: machine with automatic idler (sec-
ond version).
See gure 6 / C: machine with automatic idler (third
version).
For the type of fuel to be used, refer to the instruction
manual of the engine by checking the identication
information on its nameplate.
The fuel tank and the cap are placed on the engine.
For the type of engine oil, refer to the engine manual,
also verifying the data given on the motor nameplate.
Recommended oil for the hydraulic system: «HY-
DRAULIC EP ISO 46» or equivalent oil.
ENGLISH

Fort VISION Specifications

General

Brand	Fort
Model	VISION
Category	Tractor
Language	English