Copying Procedure
101
3 If the previous settings still remain, select [Reset].
4 Configure each feature as necessary.
Step 3 Entering a Quantity
You can enter up to 9999 sets.
Step 4 Starting the Copy Job
The following describes how to start a copy job.
1 Select [Start].
z
If the document has been loaded in the document feeder, do not hold down the document while it is being
conveyed.
z
If a problem occurs, an error message appears on the touch screen. Follow the instructions of the message to
solve the problem.
z
You can set the next job during copying.
If you have more documents
If you have more documents to copy, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to scan the documents as a single set of
data.
2 Select [Next Original] while scanning is in progress.
To Next Page
Loading...
Need help?
General
