Loading Paper
75
7 Specify the type of the paper loaded when you have changed the paper type.
z
For more information on paper type settings, refer to "Changing the Paper Settings" (P.89).
Loading Paper in Tray 6 (High Capacity Feeder B1-S)
The following describes the procedure for loading paper in Tray 6 (High Capacity Feeder
B1-S (optional)).
z
Before loading paper in a tray, fan the paper well. It prevents paper from sticking to each other and reduces
paper jams.
z
When loading heavyweight paper, be sure to adjust the position of the weight switch buttons.
1 Pull out the tray towards you until it stops.
z
While the device is processing a job, do not pull out the tray.
z
Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper jams or any other
troubles.
2 Remove any paper loaded in the tray.
3 With the side to be copied or printed on facing up, load approximately 100 to 500 sheets of
paper in the tray and align the edges of the paper in the arrow direction (1). Hold the long-
side paper guide and slide it to the desired paper size (2).
To Next Page
Loading...
Need help?
General
