Replacing Staple Cartridge (for Finisher D6 with Booklet Maker)
135
Replacing Staple Cartridge (for Finisher D6 with
Booklet Maker)
When the optional finisher is installed and it is time to replace the staple cartridge, a
message appears on the touch screen. When the message appears, replace the staple
cartridge with a new one.
z
The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance. Use
staple cartridges recommended by Fuji Xerox.
z
When the device is in Power Saver mode, wake the device from the Power Saver mode by pressing the Power
button and select [Machine Status] on the Home screen before you replace the booklet staple cartridge.
z
When replacing the staple cartridge, select [Machine Status] on the Home screen and check the current
status for the booklet staple cartridge even when the touch screen is lit.
z
To order a staple cartridge, contact our Customer Support Center.
z
If the staple cartridge was not replaced properly, the message remains on the touch screen. Follow the
procedure and replace the staple cartridge again.
1 Make sure that the device has stopped, and open the finisher front door.
2 Pull out [R1].
3 Hold the staple cartridge in the direction of the arrow as shown in the figure to remove.
To Next Page
Loading...
Need help?
General
