7 Stored Programming
282
Stored Programming
7
Stored Programming Overview
The Stored Programming service allows you to store settings that you expect to use
frequently and call them with a single button operation. You can also assign a screen to a
stored program button, to use the button as a short-cut to the screen.
A stored program can store not only settings of a feature, but a flow of settings configured
on multiple screens.
For example, this service is available when you want to record a procedure starting from
pressing the <Machine Status> button, to displaying the screen under [Print Reports] to print
a Job History Report.
In addition, while Build Job is running, this service can be used for the remaining document
stacks.
For information on Build Job, refer to "Build Job (Processing Documents Scanned with Different Settings as One Job)"
(P.157).
Note • Drag and flick operation cannot be registered to the stored program.
The following shows the reference section for each feature.
Registering/Deleting/Renaming Stored Programs.............................................................................................................. 283
Calling a Stored Program........................................................................................................................................................... 288
To Next Page
Loading...
Need help?
General
