3 Copy
148
Copy
3
Booklet Creation (Creating a Bound Booklet)
This feature lays out pages so that booklets are formed when the output sheets are folded
in half. You can also set the binding shift and attach a cover when making booklets.
When the Booklet Maker Unit for Finisher-B1 (optional) is installed, you can also crease the
output sheets in half, or staple the creased output sheets.
When the C3 Finisher with Booklet Maker (optional) is installed, you can also fold the output
sheets in half, or staple the folded output sheets.
Important • Ensure that the actual orientation of the original document matches the [Original Orientation]
setting on the [Layout Adjustment] screen.
• When the Finisher-B1 is installed, do not remove outputs from the finisher tray until all the output
sheets have been delivered.
Note • The machine copies four pages of the document onto one sheet of paper. If the number of pages in
the booklet is not a multiple of four, the remaining pages will be output as blank pages.
• If [Auto Select] is selected in [Paper Supply], a tray specified in [Auto Paper Off] is automatically
selected. Change the setting if necessary. For information on [Auto Paper Off], refer to "5 Tools" >
"Copy Service Settings" > "Copy Control" in the Administrator Guide.
• This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
1 Specify the orientation of the document in
[Original Orientation] on the [Layout
Adjustment] screen.
2 Select [Booklet Creation] on the [Output
Format] screen.
3 Select any option.
Off
Disables this feature.
Create Left/Top Bound Booklet
Copies are made to enable left binding or top
binding.
Create Right Bound Booklet
Copies are made to enable right binding.
Copy Booklet
You can output the copies of scanned documents as they are by specifying [Fold & Staple].
Select this option when you do not need a document to be copied in booklet page order.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
To Next Page
Loading...
Need help?
General
