2 Product Overview
78
Product Overview
2
• When switching the power off, wait 5 seconds after outputs have been delivered.
2 Press the push-button power switch.
Important • Power off processing is performed internally
on the machine for a while after the power is
switched off. Therefore, do not switch the
main power off immediately after switching
the power off.
Note • When powering the machine on after it has
been switched off, wait until the flash of the
<Power Saver> button ends after the touch
screen has gone dark.
When the Finisher-B1 (optional), the C3
Finisher (optional), or the C3 Finisher with
Booklet Maker (optional) is installed
Switching the Main Power Off
The following describes how to switch the main power off.
Important • Do not switch the main power off when a screen is displayed on the touch screen or while the
<Power Saver> button is blinking. Switching off the main power under such circumstances may
damage the hard disk and the memory or cause a machine malfunction.
• Switch the main power off first when unplugging the power cord. Unplugging the power cord with
the main power on may damage the hard disk and the memory or cause a machine malfunction.
1 Make sure that the power is switched off.
2 Make sure that the touch screen is blank and the <Power Saver> button is not lit.
3 Open the front cover.
4 Press the main power switch to the [ ]
position to switch the main power off.
The <Main Power> indicator goes out on the
control panel.
5 Close the front cover.
To Next Page
Loading...
Need help?
General
