167 Using the Operator Panel Menus
Admin Menu
Use the Admin Menu menu to configure a variety of printer features.
NOTE:
• A password is required to enter the operator panel menus when Panel Lock Set is set to Enable. In this
case, enter the password you specified, and press the button.
Network Setup
Use the Network Setup menu to change the printer settings affecting jobs sent to the printer
through the wired or wireless network.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
•Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes
effective after the printer is turned off and then on.
Values:
NOTE:
• This item is displayed only when the printer is connected with a wired network.
• Wireless Status (DocuPrint CP205 w Only)
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator
panel to improve the status of the wireless connection.
Values:
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
Auto* Detects the Ethernet settings automatically.
10Base Half Uses 10base-T half-duplex.
10Base Full Uses 10base-T full-duplex.
100Base Half Uses 100base-TX half-duplex.
100Base Full Uses 100base-TX full-duplex.
Good Indicates good signal strength.
Acceptable Indicates marginal signal strength.
Low Indicates insufficient signal strength.
No Reception Indicates that no signal is received.
To Next Page
Loading...
Need help?
General
