Network Basics 70
Configuring Wireless Settings (DocuPrint CP205 w Only)
This section describes how to configure wireless settings through Easy Install Navi.
IMPORTANT:
• The Wireless LAN feature is unavailable depending on the region you purchased.
The specifications of wireless setting function are described below:
You can select a method to configure a wireless setting from the following:
NOTE:
• For information on how to install a wireless, see "Using Wizard Setup to Configure Wireless Settings" on
page 71 or "Using Advanced Setup to Configure Wireless Settings" on page 73.
Item Specification
Connectivity Wireless
Connectivity Standard IEEE 802.11b/g/n compliant
Bandwidth 2.4 GHz
Data Transfer Rate IEEE 802.11b mode: 11, 5.5, 2, 1 Mbps
IEEE 802.11g mode: 54, 48, 36, 24, 18, 12, 9, 6 Mbps
IEEE 802.11n mode: 65 Mbps
Security 64 (40-bit key)/ 128 (104- bit key) WEP, WPA- PSK (TKIP, AES),
WPA2-PSK (AES)(IEEE802.1x attestation function of WPA 1x non-
corresponds)
Certifications Wi-Fi, WPA2.0 (Personal)
Wi-Fi Protected Setup (WPS) Push Button Configuration (PBC), Personal Identification Number
(PIN)
Wizard Setup Through USB Connection
Advanced Setup Through Ethernet connection
Operator Panel
CentreWare Internet Services
WPS-PIN
*1
WPS-PBC
*2
*1
WPS-PIN (Wi-Fi
®
Protected Setup-Personal Identification Number) is a method to authenticate and
register devices required for wireless configuration, by entering PIN assignments in the printer and
computer. This setting, performed through access point, is available only when the access points of your
wireless router supports WPS.
*2
WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register
devices required for wireless configuration, by pressing the button provided on the access point via
wireless routers, and then performing WPS-PBC setting on the operator panel. This setting is available
only when the access point supports WPS.
To Next Page
Loading...
Need help?
General
