162 Using the Operator Panel Menus
• TCP/IP
Purpose:
To configure TCP/IP settings.
Values:
*1
IPsec feature is available only when IPsec is enabled on the CentreWare Internet Services.
IP Mode Dual Stack
*
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Uses IPv4 to set the IP address.
IPv6 Uses IPv6 to set the IP address.
IPv4 Get IP Address DHCP / Autonet
*
Sets the IP address automatically. A random value in the
range of 169.254.1.0 to 169.254.254.255 that is not
currently in use on the network is set as the IP address. The
subnet mask is set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address manually
on the operator panel.
IP Address When an IP address is being set manually, the IP is allocated
to the printer using the format nnn.nnn.nnn.nnn. Each octet
that makes up nnn.nnn.nnn.nnn is a value in the range of 0
to 254. 127 and any value in the range of 224 to 254 cannot
be specified for the first octet of a gateway address.
Subnet Mask When an IP address is being set manually, the subnet mask is
specified using the format nnn.nnn.nnn.nnn. Each octet
that makes up nnn.nnn.nnn.nnn is a value in the range of 0
to 255. 255.255.255.255 cannot be specified as the
subnet mask.
Gateway Address When an IP address is being set manually, the gateway
address is specified using the format nnn.nnn.nnn.nnn.
Each octet that makes up nnn.nnn.nnn.nnn is a value in
the range of 0 to 254. 127 and any value in the range of 224
to 254 cannot be specified for the first octet of a gateway
address.
IPsec
*1
Disable Disables IPsec.
To Next Page
Loading...
Need help?
General
