240 Maintenance
Replacing the Fusing Unit, Transfer Unit and Retard Roll
You need to replace three parts (fusing unit, transfer unit and retard roll) at a time. Both the transfer unit and the
retard roll for replacement come with a new fusing unit.
Fuji Xerox fusing unit, transfer unit, and retard roll are available only through Fuji Xerox. To order by phone, see also
"Online Services" on page 263.
It is recommended that you use Fuji Xerox fusing unit, transfer unit, and retard roll for your printer. Fuji Xerox does
not provide warranty coverage for problems caused by using accessories, parts, or components not supplied by Fuji
Xerox.
This section includes:
• "Removing the Fusing Unit" on page 241
• "Installing a Fusing Unit" on page 242
• "Removing the Transfer Unit" on page 242
• "Installing a Transfer Unit" on page 243
• "Removing the Retard Roll in the Standard 250 Sheet Tray" on page 244
• "Installing a Retard Roll in the Standard 250 Sheet Tray" on page 245
• "Resetting the Counter of the Fusing Unit" on page 245
Overview
When a fusing unit or transfer unit reaches its usable life-span, the following messages appear on the LCD panel.
• Fusing Unit Safety
When removing the Fusing Unit, always switch off first and wait for 40 minutes until it cools off.
Message Remaining Page Yield Printer Status and Action
Fusing Unit Life
Replace Soon
10,000 pages The fusing unit is near the end of its life. Prepare a
new one.
Replace the fusing unit as well as the transfer unit at
the same time.
Fusing Unit Life
Replace
- The fusing unit has reached the end of its life. Replace
the old fusing unit with a new one.
Replace Transfer
Unit
- The transfer unit has reached the end of its life.
Replace the old transfer unit with a new one.
To Next Page
Loading...
Need help?
General
