EasyManuals Logo
Home>Fujitsu>Laptop>LifeBook A1010

Fujitsu LifeBook A1010 User Manual

Fujitsu LifeBook A1010
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
46
LifeBook A Series – Section Four
Memory Upgrade
Module
Your Fujitsu LifeBook notebook comes with either
128MB or 256MB of high speed Synchronous Dynamic
RAM (SDRAM), 133MHz factory installed. To increase
your LifeBook notebooks memory capacity, you may
install an additional memory upgrade module. The
memory upgrade must be a dual-in-line (DIMM)
SDRAM module. To ensure 100% compatibility,
purchase the SDRAM module only from the Fujitsu web
store at www.fujitsupc.com.
INSTALLING A MEMORY UPGRADE
MODULE
To install a memory upgrade module follow these steps:
1. Turn off power to your LifeBook notebook and
remove any power adapter (AC or auto/airline).
2. Place your LifeBook notebook upside-down on a
clean work surface.
3. Open the top cover all the way, so that it is lying flat
on the work surface.
4. Remove the screw holding the memory
compartment cover (Figure 4-7)
Figure 4-7 Removing the memory compartment cover
Figure 4-8 Installing a new memory module
5. Align the connector edge of the memory upgrade
module, chip side up, with the connector slot in the
compartment. (Figure 4-8)
6. Insert the memory upgrade module at a 45
o
angle
and press it firmly onto the connector.
7. Press the memory upgrade module down into the
compartment until it locks underneath the retaining
clip. You will hear a click when it is properly in place.
8. Replace the cover and screw that were removed
previously (Figure 4-9). Installation of the new
memory module is now complete.
Figure 4-9 Replacing the memory compartment cover.
WARNINGS
Do not remove any screws from the memory upgrade
module compartment except the one specifically
shown in the directions for installing and removing
the memory upgrade module.
You must turn off power before installing the memory
upgrade module.
CAUTION
The memory upgrade module can be severely damaged
by electrostatic discharge (ESD). Be sure you are properly
grounded when handling and installing the module.
POINT
The memory upgrade module is not something you
routinely remove from your LifeBook notebook. Once it
is installed, you should leave it in place unless you want
to increase system memory capacity.
B5FH-5121-01EN-00.book Page 46 Wednesday, April 10, 2002 11:02 AM

Table of Contents

Other manuals for Fujitsu LifeBook A1010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu LifeBook A1010 and is the answer not in the manual?

Fujitsu LifeBook A1010 Specifications

General IconGeneral
BrandFujitsu
ModelLifeBook A1010
CategoryLaptop
LanguageEnglish

Related product manuals