4. AIS OPERATION
4-15
7. Referring to the table below, set the association criteria. Rotate the ADJUST knob
to adjust the value, push the ADJUST knob to move to the next digit.
8. Close the menu.
When the association criteria (gap, range, bearing, speed, and course) is met, and the
ASSOCIATION TARGET setting is [AIS], the TT symbol is erased and only the AIS
symbol is displayed. Further, "ASSOCIATION" appears in the [ALERT] Box.
All default association settings are restored whenever the power is turned on.
4.14 How to View Own Ship Data
Own ship’s static data (type of ship, call sign, name and position of internal and exter-
nal GPS antennas) can be viewed as follows:
1. Select the [AIS] box at the right of the screen, then press the right button. The
[AIS TARGET MENU] appears.
2. Select [STATIC DATA], then push the ADJUST knob.
3. Close the menu.
[GAP]: Range in bearing direction between AIS target and tracked target.
(setting range: 0.000-0.050 (nm))
[RANGE]: Range direction difference from own ship to AIS target and tracked
target. (setting range: 0.000-0.100 (nm))
[BEARING]: Bearing difference from own ship to AIS target and tracked target.
(setting range: 0.0-9.9 (°))
[SPEED]: Speed difference between AIS target and tracked target.
(setting range: 0.0-6.0 (kn))
[COURSE]: Course difference between AIS target and tracked target.
(setting range: 0.0-25.0 (°))
AIS box
1 BACK
TYPE OF SHIP
000
ALL SHIPS OF
THIS TYPE
CALL SIGN
(call sign here)
NAME
(ship name here)
EXT GPS ANT POSN
A: 000m B: 000m
C: 00m D: 00m
[STATIC DATA]
A
B
C
D
To Next Page
Loading...
Need help?
General
